Cattani TURBO SMART HP, Instruction Manual

Page: 8 / 44

5
5a
8
cod: ed. 09-2021
Even for installations where the Smart suction units
are setup at a floor below the clinic, the suction
piping must reach the floor where the suction unit
is located, run flat along the floor for a few metres
then rise with a flexible tube up to the centrifugal
separator (fig. B, page 30), the fluid enters the
suction unit.
When assembly is completed, connect the power
cable to the electricity supply line following
regulations in force. Lastly, connect the low voltage
permissive line to the dental units dry contacts (see
wiring diagrams on page 31) Ensure that the contact
is dry (not live).