Frequently
Asked
Questions
2/11
32
Frequently Asked Questions
Measurement won’t start
•
Is [READY] flashing on the measurement screen?
Press MODE or (POWER) to start measurement.
•
Is [PAUSE] flashing on the measurement screen?
Press and hold MODE to resume measurement.
•
Is the Air GPS connected to the smartphone (Cateye Cycling™)?
The Air GPS will not show the measurement screen when it is connected to the
smartphone (Cateye Cycling™).
Turn [Connect] off in Cateye Cycling™.
The current speed becomes zero or measurement data values are strange during
measurement (when measured by the GPS)
Depending on reception conditions of the GPS signal, measurement may be
interrupted or a value inconsistent with actual one may be shown.
For more details, see
The Air GPS turns off during measurement
•
Has the Air GPS been left for 2 hours or more during measurement?
If the Air GPS is left for 2 hours with no signal or operation, it automatically turns off
after finishing measurement and saving measurement results.
•
Has the battery run out of charge during measurement?
“Charging the Air GPS” (page 3)
Power-saving screen is displayed during measurement
When no speed information is received for more than 10 minutes, the power-saving
screen is displayed.
* If a speed/cadence sensor is used, the wheel magnet may be misaligned.
Ensure that the wheel magnet is in the correct position relative to the speed-side
sensor zone.
For more details on mounting CATEYE sensors, refer to the sensor’s online manual
(on our website).