Operator's Manual
HPS09 Pellet Stove
Check for parts online at
www.castlestoves.com
or call 800-345-6007 M-F 8-5 CST
17
Figure 12: Control pad location
Figure 13: Control pad key
3
4
1
2
5
6
7
8
9
shut down Procedure
Press the button on the control pad to initiate the
shut down mode. Once this is done the auger will stop
feeding pellets, but the room air distribution blower and
exhaust fan will continue to operate. When the internal
temperature of the unit drops below the factory preset
temperature, the room air distribution blower and exhaust
fan will cease to operate and the unit will be completely
shut down.
Shut down times will vary.
control Pad key - see figure 12
1. On/Off Button - Starts and stops operation of stove.
2. Level Adjustment Button - Adjusts heat range levels
to low, med, high.
3. Power Indicator - Illuminates when the main power
switch is on.
see figure 10.
4. Fault Indicator - Illuminates when stove is
overtemped or if there is loss of fire during
startup or during normal operation.
see
troubleshooting section.
5. Auto Ignition Indicator - Illuminates when igniter is
operating.
6. Fuel Feed Indicator - Illuminates when the feed auger
is operating.
7. Exhaust Blower Indicator - Illuminates when exhaust
blower is operating.
8. Room Air Blower Indicator - Illuminates when room
air blower is operating.
Note: room air blower will not operate until stove
has reached factory preset operating tempera-
ture.
9. Heat Level Indicator - Illuminates one bar for low, two
bars for med and three bars for high.
I
Warning
never shut the stove down by unPlug-
ging it from the Power source.
never shut the stove down by switch-
ing off the main Power switch on the
rear of the stove.
never oPen side Panels or main door
when stove is in oPeration.
never touch glass door and ash Pan
latches while in oPeration, they get
extremely hot and wIll burn you.
