Cassese CS200 CART, User & Parts Manual

Page: 11 / 64

USER MANUAL CS200 CART
11
2.B AIR LINE FITTINGS
Included in the machine Customer’s air connection
Standard hose connector - Z556
Q/R US male connector - Z701
2.C CONNECTING TO THE AIR SOURCE
The machine should be connected to a pneumatic circuit providing 6 to 8 bars pressure.
If the indicated pressure is not 6 bars (85 p.s.i.), check the pressure at the air source (compressor). Then, if pressure is correct at
the air source, it means the regulator of the machine needs fine tuning. Perform the following procedure to adjust it (Figure 2-6
and Figure 2-7)
Figure 2-4
Connect the machine
using
the quick
connectors as
mentioned in chapter
0
Quick
release(Q/R)
Female
Air Connector
- Z749
Quick
release(Q/R)
Female
Air Connector
- Z749
The CS200 CART must
be connected to the
air source located on
the front panel of the
drawer. Turn the
compressed air valve
to
ON by rotating its
red knob .
The
air pressure
gauge should show 6
bars
(85 p.s.i.)
minimum.
The red knob in Figure 2-5 must be used to secure the machine during maintenance or to prevent non desired
use. A lock can be applied to it in stop position so nobody can turn it back to ON. This will exhaust air from the
machine circuit and disconnect it from air supply. Refer to chapter I.5.A
SAFETY INSTRUCTIONS (page 20) for
further instructions.
Figure 2-5