Cassese CS200 CART, User & Parts Manual

Page: 14 / 64

USER MANUAL CS200 CART
14
3.C SPECIFIC USE OF THE SPACER BARS
Example of bad
setting of the
chevron.
Pay attention to
properly position the
magnetic
chevron
clamp: the sides of
the chevron must be
parallel
to back
fences 1 and 2.
Figure 3-7
Now with quick-
change magnetic
clamps, it is easy to
change from chevron
to a round clamp.
Simply pull down the
Z24703 to change of
clamp support.
When joining small
mouldings
(lower
than the height of
the back fences), it is
necessary to use the
set of spacer bars
supplied with the
machine.
This is an example of
a bad setting, the
spacer bar not being
used will cause the
top clamp not to hold
the
moulding
correctly. The
moulding will jump
up during stapling.
Figure 3-10
Figure 3-11
Figure 3-9
Figure 3-8
SPACERS
The spacer bars are
made of two steel
bars linked with a
screw locked by a
nut. The nut side is
the bottom side of
the spacer bars
Here the spacer bars
are upside down.
The nut is visible on
the top, which is not
correct.
Figure 3-12 Figure 3-13