Cassese CS200 CART, User & Parts Manual

Page: 13 / 64

USER MANUAL CS200 CART
13
3 ADJUSTMENTS
3.A ADJUSTMENT OF THE SLIDING TABLE
3.B PROPER ADJUSTMENT OF MAGNETIC ADJUSTABLE ROD CLAMP
The sliding table (see
page 6) needs to be
adjusted to be able to
set
the various
stapling positions.
To do this, switch on
the Pre-Clamp button.
Unscrew the sliding
table handle.
Install one moulding
on the table as per
picture attached.
Shift the sliding table
in order to tighten
the moulding with
the rebate clamp (see
page 6).
Then tighten the
sliding table handle . Switch back off the
Pre-Clamp button in
order to release the
mouldings
and
remove the moulding
that was against the
back fence.
Figure 3-5
When adjusting the vertical rod clamp, closer it is from the top of the moulding, and faster will be the
machine. The machine will not damage the moulding, even if the distance is very close. If the distance
is superior to 50mm, the wedge will not penetrate fully inside the wood.
A magnetic
adjustable rod
clamp comes with
your machine as a
standard feature. It
fits the crossbar
thanks
to the
locking ring and
can be set at 1 to 7
positions.
Figure 3-1 Figure 3-2
Pull the black knob to
be able to adjust the
space between the
vertical clamp and
the
top of the
moulding. You must
have 50mm (2”) max
between the clamp
and the top of the
moulding.
Figure 3-3 Figure 3-4
Figure 3-6