Cassese CS200 CART, User & Parts Manual

Page: 10 / 64

USER MANUAL CS200 CART
10
2 SETUP
2.A UNPACKING THE MACHINE
After unpacking the
machine, install and
set the 4 feet to level
the machine. Make
sure the 4 feet are
touching the floor,
machine must be
steady.
When installing the machine, make sure the floor will be flat and strong enough to support its weight. It should
be installed in a dry environment providing temperate temperature. The floor should be flat and clean. Select
a location with proper lighting.
When levelling the machine, if the machine is installed against a working table, make sure a long frame will not
be risen up by the table, because this would cause bad joining. Working table and machine should be levelled
together.
Figure 2-2 Figure 2-1
Remove the 4 bolts to
free the machine from
the crate. They are
located under the
pallet.
Cut both plastic strips
in order to free the
box and lift up the
wood cover with the
help of a second
person.
Figure 2-3
Cutter
Flat span N.13 & N.17
Allen key N.5
Bubble level