33
Charging the Battery with the AC Adaptor
Pull back the rubber cover from the AC adaptor jack and insert the
cable. The battery pack takes about two hours (when the Rugged PDA
is turned off) to fully charge, and then the left side indicator LED lights
green. When the battery pack is fully charged, remove the AC adaptor
cable and be sure to replace the rubber cover to its original position.
Remove the AC adaptor cable in the following order
q
→
w
→
e
.
If the left side indicator LED goes out during charging, then the internal
protection circuit may have terminated charging. If this happens, re-
move the AC adaptor and the battery pack from the Rugged PDA and
then reattach them again and then start charging again. If this hap-
pens frequently it may indicate a malfunction, contact your original
retailer or authorized distributor.
N o t e
•
You can use the Rugged PDA while it is charging. However,
the time to charge the Rugged PDA may vary greatly de-
pending on the operations (and temperature or other factors).
•
Charging requires a longer than normal time when doing ini-
tial setup immediately after purchase or when charging a
newly purchased battery pack for the first time.
q
e
w
Warning!
Use the AC adaptor specified by the manufac-
ture. Using the AC adaptor that is not specified
by the manufacturer may cause a fire.
DT-10̲1章/21-35.p65
04.9.30, 17:27
Page 33
Adobe PageMaker 6.5J/PPC