23
Quick Start Basics
.
Camera-Controller Wireless Connection
The camera and controller communicate over a Bluetooth wireless technology
connection. Once you register a camera on the controller, a Bluetooth wireless
technology connection will be established automatically between them whenever you
turn on camera and controller power. Note that the connection will be lost when the
distance between the camera and controller becomes too great. The controller will
turn off after a preset amount of time after the Bluetooth wireless technology
connection is lost.
IMPORTANT!
• Your controller has Bluetooth wireless technology communication functionality built
in. Avoid operating it inside of aircraft or anywhere else where wireless data
communication is restricted.
.
To turn on power
Press [
p
] (Power).
• If the camera is registered on the controller, turning
on power causes the controller operation lamp to
light green, and automatically starts an operation to
establish a Bluetooth wireless technology connection
between the camera and controller. An image will
appear on the controller when shooting is enabled.
• The connection between the camera and controller is
affected by their orientation and by the distance
between them.
• The maximum range for shooting with the controller’s [
r
/SLOW] is around
10 meters (32.8'). The maximum range for viewing the image on the controller’s
monitor screen is around five meters (16.4').
• If the connection is poor, the controller operation lamp will flash green and
(Communication status between camera and controller) will appear on the
monitor screen. Camera response may be slow if you perform an operation on the
controller while communication conditions are bad. If this happens, try adjusting the
orientation and the distance between the camera and controller.
• Note the precautions below to ensure stable
communication between the camera and
controller.
– Make sure nothing is blocking the gray areas
shown in the illustrations.
– Point the back of the controller at the
camera.
– Make sure there are no obstacles between
the camera and controller.
Turning Power On and Off
[
p
] (Power)
Operation lamp
