2 - SAFETY INFORMATION
Getting on and off the machine
• Inspect steps and hand holds to ensure they are in good
working order.
• Use the recommended hand holds and steps with at
least three points of support when getting on and off
the machine. The door must be latched and secured in
the open position before using the door hand hold.
• Face the machine and use the hand holds and steps
adhering to a three-point access system when climbing
up and down.
• Do not jump off the machine.
• Do not dismount while the machine is in motion.
• Foreign material or grease on the steps, platform and
hand rails can cause an accident. Keep steps, platform
and hand rails clean.
LEIL15WHL1811AA
1
Starting and stopping precautions
• Walk around the machine and warn all personnel who
may be servicing the machine or are in the machine
path prior to starting. Do not start until all personnel
are clearly away from the machine. Sound the horn, if
equipped, before starting.
• Walk around the machine’s tool, attachment, or further-
most contact point to view operation danger area from
the work site personnel’s view and angle.
• Check that the parking device is applied, place the
transmission in neutral or park as specified by the
manufacturer, before starting the machine.
• Adjust, secure and latch the seat and fasten the seat
belt before starting the machine.
• Start and operate the machine only from the operator's
station.
• Do not bypass the machine's neutral-start system. The
neutral-start system must be repaired if it malfunctions.
• Use battery booster cables only in the recommended
manner. Improper use can result in battery explosion
or unexpected machine motion. Ventilate the battery
area before using booster cables.
• Do not operate the engine in an enclosed area without
adequate ventilation.
• Park the machine on level ground whenever possible
and apply the parking brake. On grades, park the ma-
chine with the wheels securely blocked.
• Before leaving the operator's station, lower the bucket/
attachment to the ground and shut off the engine.
• Remove the starter key and/or use the timed discon-
nect switch when leaving the machine parked or unat-
tended.
2-4
Summary of Contents for 621G Stage IV
