Case 621G Stage IV, Original Instructions Manual

Page: 221 / 430

7 - MAINTENANCE
Transmission component oil
Extreme pressure oil must be used for enclosed trans-
mission components. Choose an oil that is manufactured
for your climate/temperature conditions such as
CASE
AKCELA NEXPLORE™ FLUID . See the charts at the be-
ginning of this section.
Front and rear axle oil
Extreme pressure oil must be used for enclosed axle com-
ponents. Choose an oil that is manufactured for your cli-
mate/temperature conditions such as
T
UTELA
T
RANSAXLE
FLUID
SAE 80W-140 .
Grease
T
UTELA
M
OLY
G
REASE
GR-75 .
Environment
Before you service this machine and dispose of oil, fluids,
and lubricants, obey environmental regulations. Do not
drain oil or fluids on to the ground or into containers that
leak. Check with your local environmental, recycling cen-
ter or your dealer for correct disposal information.
Engine oil
CASE AKCELA UNITEK NO. 1™ SBL CJ-4 is recom-
mended for your engine. This oil insures correct lubrica-
tion of your engine in all working conditions. See charts
at the beginning of this section to choose the correct oil
for climate/temperatures.
If CASE AKCELA UNITEK NO. 1™ SBL CJ-4 cannot be
obtained, use only oil of the API SERVICE CJ-4 or ACEA
E7/E9 category.
You may also use CASE AKCELA NO. 1™ ENGINE OIL
in your engine. CASE AKCELA NO. 1™ ENGINE OIL
has a maximum service change interval of 400 h .
NOTE: do not put any Performance Additive or other addi-
tive in the sump. Oil change intervals shown in this man-
ual are based on tests carried out utilizing CASE CON-
STRUCTION lubricants.
7-13