Cascade Sciences CVAC-9.3, Installation & Operation Manual

Page: 39 / 54

39 | P a g e
cascadesciences.com | Tel. 503 847-9047
OPERATION
Note: There may be light smoking from protective oil coatings on the elements when running the
oven at or near its maximum temperature for the first time.
P
UT THE
O
VEN INTO
O
PERATION
Perform the following steps and procedures to prepare the oven for use in a new location.
Continued on next page
1.
Reset the Heating Power Relays
If this is the first use of the oven, push the Reset
button to reset the heating element power
relays.
•
The oven display will not power up unless the
relays are set.
•
Do not push the gray Reset button on the
controller.
2.
Turn on the Oven
Place the oven Power Switch in the ON ( I )
position.
The controller display will illuminate and default
to its home page.
3. Verfiy the integrity of the vacuum system
10 Minute Minimum
Place the Chamber Under Vacuum for 10 minutes
to verify the integrity of the vacuum supply system.
See page 41.
You may leave the chamber under vacuum to
perform the Set the Over Temperature Limit
procedure.