cascade corporation 20G, Original Instructions Manual, Page: 20 / 24

18 6033701-R9 EN
PERIODIC MAINTENANCE
CL5702.eps
External Sideshifter
Grease Fittings
Socket Capscrew
Hex Capscrew
External Sideshifter
Lower Bearing
Grease Areas
External Sideshift Cylinder
Mounting Capscrews
Lower Hook
Capscrews
External Sideshifter
Lower Spacer
Capscrews
Type 1
Type 2
External Sideshifting Clamp
Back (Driver's) View
Lower Spacer Types
External Sideshifter
Attachments with
External Sideshift
In addition to (or in place of, where necessary) the periodic
maintenance found in the "General" periodic maintenance
schedule (page 17), perform the following for attachments
with external sideshift equipped:
1000-Hour Maintenance
• Tighten external sideshift cylinder mounting capscrews:
Socket Capscrew (Upper):
20G – 36G, 44G (CL II) – 285 Nm
44G (CL III), 52G – 520 Nm
64G, 70G – 445 Nm
Hex Capscrew (Lower):
20G–36G, 44G (CLII) – 235 Nm
44G (CL III), 52G – 520 Nm
64G, 70G – 445 Nm
IMPORTANT: If any capscrews are found loose, remove
attachment from truck and check all sideshifter mount
capscrews for proper torque values.
• Tighten the following accessible mounting plate and
lower spacer capscrews. Double-torque capscrews by
tightening to final torque value, loosen 1/2 turn, then
retighten.
Mounting Plate and Type 1 Lower Spacer:
20G – 108 Nm
28G, 36G, 44G – 270 Nm
52G – 435 Nm
Mounting Plate and Type 2 Lower Spacer:
20G – 108 Nm (M12), 225 Nm (M16)
28G, 36G, 44G – 270 Nm
52G – 270 Nm (M16), 520 Nm (M20)
IMPORTANT: If any capscrews are found loose, remove
attachment from truck and check all mounting plate and
lower spacer capscrews for proper torque values.
• Tighten cylinder rod end anchor bar capscrews.
12G-18G (Carton Clamps only)– 225 Nm
20G – 63 Nm
28G, 36G – 90 Nm
44G-70G – 225 Nm
500-Hour Maintenance
• Inspect external sideshifter bearings for wear or
damage. If upper bearings are worn to less than 1.5
mm thickness, replace bearings. If lower bearings are
worn to less than 1.5 mm exposed thickness, replace
bearings.
• Apply general-purpose chassis grease to external
sideshifter upper bearing grease fittings and lower
bearing areas.
• Check lower mounting hooks for engagement clearance
of 1.5 to 5 mm.
• Tighten lower bolt-on hook capscrews:
CL II, CL III – 165 Nm
CL IV – 435 Nm
CL6118.eps
CL6157.eps