7
K
ey
L
argo
™
II
REmOVE DUmmY SWITCH HOUSINg & SHIppINg BLOCKS
Step 7a.
To reach the blade holder mounting
holes in the fan motor the dummy switch
housing must be removed.
Take out the two 6-32 X
3
/
8
” screws securing
the dummy switch housing and remove. Put
the two (2) screws aside for the moment,
they will be used in Step 10 to install
the switch housing after the blades are
installed.
The dummy switch housing is used only when
shipping the fan.
note:
Save these two screws–they
will be used in Step 10!
Step 7b.
Unscrew and remove the 10 ship-
ping blocks. Put the ten screws aside for the
moment, they will be used in Step 8.
The shipping blocks can be discarded; they
are used only when shipping the fan.
SHIppINg
BLOCKS
BLADE SCREW
AND WASHER
(4 pER BLADE)
BLADE & BLADE HOLDER HARDWARE
BLADE
HOLDER
BLADE HOLDER
SCREW
(2 pER BLADE)
Step 8.
Attach each blade to a blade
holder by first pressing the blade badge
into the blade, then installing the blade
holder using the four blade screws pro-
vided for each blade.
Using a screwdriver tighten securely by
hand
only.
Repeat for each blade assembly
BLADE SCREW
AND WASHERS
(4 pER BLADE)
BLADE
(SOLD SEpERATELY)
BLADE
HOLDER
BLADE BADgE INSTALLATION
