10
11
a
ntion
™
CAUTION: The Motor Adapter has a special
coating on the threads. Do not remove this
coating; the coating prevents the downrod
from unscrewing. Once assembled, do not
remove the downrod.
Step_5._
Slide the hanging adapter cover down over
the motor coupling as shown in Figure #5, making sure
that the adapter cover is covering the motor coupling
as in shown Figure #6.
FIGURE_5.
FIGURE_6.
HANGING THE FAN
Step_1._ Trim wires to about 6" from the top of the
downrod.
Step_2._ Strip 1/2" of insulation off each wire using
wire strippers. Raise the fan and place the ball into
the hanger bracket.
Step_3._ Align the notch on the ball with the indent
in the hanger bracket. (Rotate the fan until you hear
the notch pop into place.)
Indention
Notch
WARNING:_
Fan may fall if
not assembled as directed
in these installation
instructions.
Power_From_
Ceiling
Line_Power_
(IN)
Line_Neutral__
(IN)
White_
Neutral_From_
Ceiling
Step_1._ Locate the White
Line Neutral (IN)
and
connect it to the White Neutral Wire from your
ceiling using one of the supplied orange wire caps.
Step_2._ Connect the Black
Line Power (IN)
and the
Black Power Wire from your ceiling with an orange
wire cap.
Step_3._ Tuck the White and Black connected wires
back into the ceiling box through the hole in the
center of the Hanger Bracket while you slide the
Receiver into the open end of the Hanger Bracket as
shown.
NOTE: Ensure you do not tuck the bare ground
wire from the ceiling back into the box. This will be
connected later.
Bare_Ground_
Wire
Tuck_Wires_
in_Box
WIRING HARDWARE
Receiver
Blue Wire Caps (3)
Orange Wire Caps (3)
WIRING
Blue_-Downlight_
Power
Step_4._ Connect the Blue
Light Out
Wire from the
Receiver to the Blue Wire coming from the fan with
a blue wire cap.
Step_5._ Take the White
Neutral Out
Wire and
connect it to the White Wire coming from the fan
with a blue wire cap.
