CAS RW-10Z, Owner'S Manual

Page: 19 / 34

20
PRINT
SET – PRINT – AUTO PRINT : Setting whether to use automatic printing
Determine whether to print automatically or not by using ▲ key and ▼ key while Detailed
Menu ATOPRT is displayed. Save the setting and exit by using LEVEL3 key.
MANUAL: Use manual printing
AUTO: Use automatic printing
Automatic printing will operate only when weight has been applied to all set PADs.
Even if automatic printing has been set, you can start printing by pressing the PRINT key.
SET – PRINT – AUTO SAVE : Setting whether to automatically save DATA
Determine whether to save DATA or not by using ▲ key and ▼ key while Detailed Menu
ATOSAV is displayed. Save the setting and exit by using LEVEL3 key.
Up to 140 truck DATA can be stored.
SAVE: Truck DATA is stored in the internal memory at the time of printing.
NO SAVE: Does not store the truck DATA at the time of printing.
SET – PRINT – SPACE : Set the interval of printing.
Change the printing interval by using ▲ key and ▼ key while Detailed MenuSPACE is
displayed. Save the setting and exit by using LEVEL3 key.
You can select 1~ 9 LINEs.
DB
Used in initializing the memory data.
(Weighing data, vehicle number and number of weighing made)
SET – DB – RESET : Delete all the DATA in the memory
When ▲ key is pressed while Detailed Menu ‘’rESEt’ is displayed, then PASS message will
appear. Enter the PASSWORD (PASS 3070). When the PASS Word is inputted and the
SET key pressed, then it is confirmed with the “SUrE” message. If you definitely wish to
delete, then press the SET key once again to confirm the “CLr Ok” message. “rESEt”
message will appear again. If you do not wish to delete, then exit by pressing the CLR
key. ”Not Clr” message will then be displayed.
In the event of entering wrong password, ”nG” message will be displayed and you will be
exited from this menu.