3
M10077EN
ELECTRICAL RATINGS:
All wiring must conform to Canadian electricity code and to local and NEC/CEC codes. Copper wire only. PRECAUTION:
Connect only to a circuit protected by a class‐A ground fault interrupter.
Power: 110 à 130 V CA, 2A, 50/60Hz or 220 à 250 V CA, 1A, 50/60Hz
Timer: Connect to load side. Remote Control unit: Connect to line power
SUITABLE FOR INDOOR OR OUTDOOR MOUNTING
Imported by:
CARVIN POOL EQUIPMENT
4000 Boul. Casavant Ouest – Saint‐Hyacinthe (Québec) Canada J2S 9E3
LED Indicator
Flashing
Continuous
Power
Power is present.
Generating
Water is too hot or too cold to operate
Chlorine is being produced
Super Chlorinate
Super Chlorinate—Chlorine generation is at 100%
regardless of "Desired Output" setting.
Remote Controlled Remote Control is in Service or Time‐Out mode—
the SANICLEARSANICLEAR system switch and dial
temporarily control operation.
Remote control System is controlling the
operation of the SANICLEARSANICLEAR
system.
No Flow
The CGS System is temporarily paused after the
flow is established.
Water is NOT flowing through the
SANICLEARSANICLEAR system cell— Chlorine
generation is halted.
Check Salt
Salt is below 2600 ppm. SANICLEARSANICLEAR
system is working at reduced efficiency. Check
SANICLEARSANICLEAR system cell and clean if
necessary. If problem persists, have the salt level
professionally tested before adding salt to the
pool.
Salt is below 2300 ppm. Chlorine generation is
halted. Check SANICLEAR system cell and clean if
necessary. If problem persists, have the salt level
professionally tested before adding salt to the pool.
High Salt
Salt concentrations above 3800 ppm: everything is
working well for the moment but the production of
chlorine could halt if the temperature rises.
Cell current too High. Chlorine generation is halted.
See operation manual for directions on decreasing
salt level.
Inspect Cell
Reduced SANICLEAR system cell efficiency or
scheduled 3 month cell inspection time. Inspect
SANICLEAR system cell and clean if necessary, and
press display button for 3 seconds to turn off
flashing indicator.
SANICLEAR system cell efficiency greatly reduced.
Inspect SANICLEAR system cell and clean if necessary. If
SANICLEAR system cell is clean it may be at the end of
its life and needs to be replaced.
Inspect SANICLEAR system cell every 3 months/clean if necessary
