Remote System
Usage and maintenance
User Manual
7 / 30
Rev. 01/11/2021
4.2.6.3
Tally led
The
Tally
led is an indication of the tally status on the remote controlled camera.
4.2.7
Settings Mode
The
Settings Mode
allows to set additional parameters.
Settings Mode
is automatically entered while the system is in the disabled status (blue status led).
In
Settings Mode
you can:
1.
Set the movement Soft Limits for each axis.
4.2.7.1
Setting the Soft Limits
To set the axis limits, press the limit button on the console when in the disabled status.
Steps to configure the limits:
Action/Status
Status led
Button led
System disabled and Settings Mode is active
Blue
Off
Press the limit
button
(for less than 2 seconds)
Yellow
Off
The axis selected is enabled and it can be moved. Move the
axis to the desired limit position then press the limit
button
again to set the first limit
Purple
Blinking
Move the axis to the second limit position and press the
limit
button
again to set the second limit. The system will go
back in disabled status and the limits are enabled
Blue
On
Table 6: Limit setting procedure.
Once the limits are set, to toggle the limits on/off press the limit
button
for more than 2 seconds, the status
led turns yellow to indicate that you can release the button.
You can set the limits only for one axis at a time.
4.2.8
Connectors panel
Connectors (11) connect encoded input devices like e-Cube (§4.5.1) and Wheels (§4.5.2).
Connector (12) connects the tally output to a monitor.
Connector (13) let you to connect a joystick (§4.5.3) or the auxiliary momentary disabling button (§4.5.6).
Connector (14) with a USB cable let you to update the firmware (§6.2).
Connectors (15) and (16) are analog inputs for Zoom (§4.5.4), Focus (§4.5.5).
