Remote System
Usage and maintenance
User Manual
18 / 30
Rev. 01/11/2021
4.6.5
Encoder cables
The Encoder cable is used to connect the encoded
device (e-Cube or Hand wheel) to the control
console. The code A351 contains 1 connection
cable.
4.6.6
Lens motors connection cables
These cables connect the lens motors (§4.4).
Code A372 is used to connect the motors to the remote head and code A374 is used to connect two motors
(See Figure 3).
4.6.7
Emergency push button
The emergency push button is connected to the AC
line before the power supply. If this button is
pressed, all the system is immediately shutdown.
After the button is pressed the head e-Rem25 may
remain in motion for a small amount of time due to
its inertial forces. To restore the power rotate the
red mushroom button in the clockwise direction.
4.6.8
Digital lens data cables
Both Canon and Fujinon broadcast and box lenses
are supported. On digital lenses Zoom and Focus
control and remote actuation of the VTR and RET
are supported. On analog lenses the actuation of
VTR and RET is supported only on Fujinon lenses
with 12 poles Hirose connectors.
See "Annex C: Lens compatibility" for a more
exaustive list.
4.6.9
Tally feature
It is available a light sensor, connected to the remote head (13 in Table 8), to sense the tally light of the
camera. The camera tally light is mirrored on the console (4 in Table 2).
An additional open ended cable is available to drive an external tally light (connector 12 in Table 2).
