66
When installing, connect the black/yellow wire of the primary ignition coil with the
black/yellow connector of CDI, and the green wire with the green connector of CDI.
• Clean the fifth and carbon accumulation on the spark plug with a steel brush or a blade.
• Inspect the spark plug gap, in general it should be about 0.6 ~ 0.7mm.
• When the carbon accumulation and wear of the spark plug are too severe, replace the spark
plug. Replace with the spark plug of the same specification.
Chassis
REAR AXLE REMOVAL
• Disassemble RR. Wheel.
• Remove the cotter pins on axle nut, RR. wheel.
• Remove the axle nut, RR. Wheel.
• Block up rear end of the machine.
• Remove rear wheel and hub assembly by sliding splines off of axle.
• Remove the chain.
• Loosen nuts on bearing carrier and remove bolts.
• Remove axle and bearing carriers as a unit.
REAR SWINGARM
Note: Swingarm, axle and motor can be removed as a unit if needed.
• Remove rear shock.
• Remove rear brake caliper and set aside.
• Do not remove brake hose!
• Unplug brake light wiring from the electrical box.
• Remove throttle cable.
• Remove bolts from swingarm pivot.
• Check Buffer Rubber Bushing for wear. If wear is present on bushing, it should be replaced.
Summary of Contents for Talon 150 DLX Series
Page 1: ...Talon 150 GX FX DLX Series Service Manual...
Page 4: ......
Page 8: ...4 LOCATION OF PARTS...
Page 76: ...72...
