56
OIL SYSTEM INSPECTION AND SERVICING
1. Check all lines for leaks and cracks.
2. To replace an oil line first make sure the end is cool and that the oil inside is not hot. Loosen the
bolt on both ends of the hose, and take the hose out and replace with new hose, retighten bolts.
3. Oil filter, replacement, and changing of the oil.
a. On the bottom of the engine block case there is a 1/2 bolt head. Turn this counter clock wise
to loose and drain oil. After the oil is drained, replace and retighten bolt clockwise.
b. The oil filter is removed by turning clockwise by using a coil filter wrench, when remove. Fill
the new one with oil 2 mm from the top. Replace the oil cooler turning counterclockwise. En-
gine MFG suggest that you change your oil and filter after 40 hours of use.
Electric System
CHARGING SYSTEM INSPECTION AND SERVICING
ELECTRIC LEAKAGE TESTING
• Turn the main switch to the “OFF” position.
• Disconnect the negative ground wire from the battery.
• Connect the positive end of the ammeter with the negative end of the battery.
• Connect the negative end of the ammeter with the ground wire.
• Test the electric leakage. In general, it demands the number should be less than 1 m A; if it is
unusual, check if there is a short circuit of the main switch and the main wiring.
CHARGING STATUS INSPECTION
• Install the fully charged battery.
• Connect the voltmeter between the binding posts of the battery.
Summary of Contents for Talon 150 DLX Series
Page 1: ...Talon 150 GX FX DLX Series Service Manual...
Page 4: ......
Page 8: ...4 LOCATION OF PARTS...
Page 76: ...72...
