Mounting, installing and interconnecting
20
Version; 1.3
Connect
Magnetic cellular antenna
to connector (12) on the
front panel
For GPS USGs, connect the
Magnetic GPS antenna
to connector (13)
on the front panel
For Ethernet USG
Connect LAN cable (RJ45) to LAN connector (2) on the front
panel
Connect the other end of the LAN cable to an available LAN.
Make sure that this LAN connection has direct access to the
internet and it is not firewalled.
For thorough technical information, refer to
Plug adapter
AC or DC Power Supply
to PWR connector on USG front
Panel(7)
AC power supply
- Plug the AC Power Supply to the electrical
outlet
DC power supply
- Plug the DC Power Supply to the Cigarette
lighter outlet (for any mobile gateway such as Dashboard
Gateway).
3.3.5
U-Sensor Gateway activation
After the U-Sensor Gateway setup is completed, do the following (refer to
Figure 9 and Table 7 for USG controls):
Turn on the U-Sensor Gateway via the on/off switch (6). At first it
will undergo a sequence of LED tests and eventually will turn Red.
Make sure that the SIM card you are using fulfills the SIM Card Requirements.
Make sure that the SIM card you are using is supported by CartaSense
In some cases a dual antenna that supports both GPS and Cellular antenna can be used.
A Green LED on the Power Adapter indicates that it provides power feed to the USG.
