Installing the UPC Open
UPC Open
Carrier Proprietary and Confidential
CARRIER CORPORATION ©2017
Installation and Integration Guide
All rights reserved
13
If the Equipment Touch will be:
•
Daisy-chained on the Rnet with ZS sensors or a Wireless Adapter, use the standard 4-conductor Rnet wiring
and follow the wiring instructions
To wire a ZS or SPT sensor to the UPC Open
(page 10).
•
The only device on the Rnet, you can use a 2-conductor cable instead of the standard 4-conductor Rnet cable
and follow the instructions below.
For complete Equipment Touch installation instructions including wiring diagrams, see the
Equipment Touch
Installation and Setup Guide.
1
Turn
off
the UPC Open's power.
2
Partially cut, then bend and pull off the outer jacket of the cable. Do not nick the inner insulation.
3
Strip about .25 inch (.6 cm) of the inner insulation from each wire.
4
Wire the UPC Open's
Rnet+
and
Rnet-
terminals to the terminals of the same name on the Equipment Touch's
connector.
NOTE
If using shielded wire, connect the shield wire and the ground wire to the
Gnd
terminal.
5
Turn
on
the UPC Open's power.
6
Turn on the Equipment Touch.
