Carrier TruVu UCXP683T-V, Installation And Startup Manual

Page: 57 / 76

To set up the controller through the Service port
TruVu™ UCXP683T -V CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
53
Local Devices table
Status The following are the results of changing Mode , Address , Location , or pressing
Blink :
•
Success - Successful operation
•
No Response - Device is not communicating
•
Device Locked - Device must be unlocked before you can make any
changes using the Local Devices table. You can unlock the TV-UCXP683T-V
by pressing the DSC button on the device or by using the i-Vu® application.
(See instructions above.)
NOTE The status of a device changes to locked 24 hours after unlocking it.
•
Failure - A conflict between the device and the information entered
Blue dot A blue dot appears for the most recent device to have the:
•
Blink button clicked in the table
•
Address or Location entered
•
DSC button pressed on the device
NOTE If the device is not already listed in the table, pressing the DSC
button immediately adds it to the table and displays a blue dot.
TIP You can build a table of devices in the order that you’ve pressed the
DSC buttons. Clear the table and then press each DSC button in turn. The
devices will be listed in the table in the order in which the button was pressed,
but only the most recent one will show the blue dot.
Blink Click the Blink button to prompt the Locator LED to flash for 15 seconds,
allowing you to verify the controller's physical location. After flashing, whenever
the actuator moves, the LED rotates in the same direction. LED rotation is
automatically disabled after 1 hour and can be re-enabled by pressing the Blink
button again.
At the same time, the Sys and Net LEDs blink white, once per second for 10
seconds, and then stop.
NOTES
•
The blue dot appears when you Blink a device.
•
You can Blink a locked device.
NOTE If a device's IP address is the loopback address (127.0.0.1), it is considered unconfigured and unlocked.
The IP address, subnet mask, and default gateway fields are blank in the Ports and Local Network tabs. You can
configure it in the Local Devices table.