– 123 –
10-1-5. Wiring and Setting of Remote Controller Control
(Setup method)
One or multiple indoor units are controlled by
2 remote controllers.
(Max. 2 remote controllers are connectable.)
<Wired remote controller>
How to set wired remote controller
as sub remote controller
Change DIP switch inside of the rear side of the
remote controller switch from remote controller
master to sub.
[Operation]
1. The operation contents can be changed by Last-push-priority.
2. Use a timer on either Master remote controller or Sub remote controller.
1 2
1 2
1 2
Remote controller
(Inside of the rear side)
Sub remote
controller
Master remote
controller
DIP switch
2-remote controller control
(Controlled by 2 remote controllers)
This control is to operate 1 or multiple indoor units
are operated by 2 remote controllers.
(Max. 2 remote controllers are connectable.)
• When connected 2 remote controllers
operate an indoor unit
<Wireless remote controller>
How to set wireless remote controller to sub
remote controller
Change OFF of Bit [3: Remote controller Master/Sub]
of switch S003 to ON.
<In case of 4-way Discharge Cassette Type>
Replace OFF with ON of the Bit SW
[Remote controller Master/Sub].
<In case of Under Ceiling Type>
How to set wireless remote controller as sub
remote controller
Turn Bit [3: Remote controller Master/Sub] of the switch
S003 from OFF to ON.
Terminal block for remote controller wires
Remote controller wires
(Procured locally)
Indoor unit
Outdoor unit
Remote controller
switch (Sub)
Remote controller
switch (Master)
Sold
separately
2
1
3
2
1
3
B
A
B
A
B
A
Sold
separately
DIP switch S003
Bit 1: OFF
→
ON
1
2
3
4
O N
Sensor cover
Sensor board
Adjust corner cap
with sensor
1
2
3
4
ON
ON
S003
Bit 3 : OFF
→
ON
1
2
3
4
ON
ON
Rear cover
Sensor P.C. board
Upper case
<In case of
Wireless remote controller kit>
[Remote controller Master/Sub]
DIP SW