CL-2
III. PRELIMINARY CHECKLIST ITEMS (cont)
CHANGES TO DEFAULT VALUES
RECORD ALL CHANGES MADE TO FACTORY DEFAULT VALUES
IV. START-UP
CHECK EVAPORATOR FAN SPEED AND RECORD. __________
CHECK CONDENSER FAN SPEED AND RECORD. __________
AFTER AT LEAST 10 MINUTES RUNNING TIME, RECORD THE FOLLOWING MEASUREMENTS:
ELECTRICAL
SUPPLY FAN AMPS
__________
EXHAUST FAN AMPS __________
ELECTRIC HEAT AMPS L1 __________ L2 __________ L3 __________
TEMPERATURES
OUTDOOR-AIR TEMPERATURE __________F DB (Dry-Bulb)
RETURN-AIR TEMPERATURE ____________F DB __________F WB (Wet-Bulb)
COOLING SUPPLY AIR _________________F
PRESSURES
GAS INLET PRESSURE ________ IN. WG
GAS MANIFOLD PRESSURE
STAGE NO. 1
IN. WG
STAGE NO. 2
IN. WG
REFRIGERANT SUCTION
CIRCUIT NO. 1
PSIG
CIRCUIT NO. 2
PSIG
REFRIGERANT DISCHARGE CIRCUIT NO. 1
PSIG
CIRCUIT NO. 2
PSIG
VERIFY REFRIGERANT CHARGE USING CHARGING CHARTS IN INSTALLATION INSTRUCTIONS
GENERAL
ECONOMIZER MINIMUM VENT AND CHANGEOVER SETTINGS TO JOB REQUIREMENTS
CHECK THE COMPRESSOR OIL LEVEL SIGHT GLASSES; ARE THE SIGHT GLASSES SHOWING OIL LEVEL
PER INSTALLATION INSTRUCTIONS. (Y/N) ________
PERFORM CONTROL CONFIGURATION PROCEDURE ON PAGES CL-3 AND CL-4.
COMP A1
COMP A2
COMP B1
COMP B2
OIL PRESSURE
SUCTION PRESSURE
SUCTION LINE TEMP
DISCHARGE PRESSURE
DISCHARGE LINE TEMP
ENTERING CONDENSER AIR TEMP
LEAVING CONDENSER AIR TEMP
EVAP ENTERING AIR DB TEMP
EVAP ENTERING AIR WB TEMP
EVAP LEAVING AIR DB TEMP
EVAP LEAVING AIR WB TEMP
COMPRESSOR AMPS (L1)
COMPRESSOR AMPS (L2)
COMPRESSOR AMPS (L3)
