Installing the i-Vu® Open Router
i-Vu® Open Router
CARRIER CORPORATION ©2020
Installation and Start-up Guide
All rights reserved
11
To connect the i-Vu® Open Router to the Ethernet
Connect an Ethernet cable to the
Ethernet Port E1
.
To wire the BACnet MS/TP network
1
Turn the i-Vu® Open Router's power off.
2
Check the communications wiring for shorts and grounds.
3
Verify that the
Port S1
jumpers are set to
485-2w
.
4
Set the MS/TP baud rate DIP switches
7
and
8
to match the baud rate of the Open network. The default is
76.8k.
5
Connect the i-Vu® Open Router's
Port S1
to the Open MS/TP network. Use the same polarity throughout the
network segment.
Wire the Port S1 terminal...
To this Open controller terminal...
Shield (Pin 1)
Shield
Net- (Pin 4)
Net-
Net+ (Pin 5)
Net+
6
Turn the i-Vu® Open Router's power on.
To wire to a BACnet ARC156 network
1
Turn
off
the i-Vu® Open Router's power.
2
Check the communications wiring for shorts and grounds.
3
Connect the communications wiring to the controller’s screw te
rminals labeled
Net +
,
Net -
, and
Shield
on the
BACnet
port.
NOTE
Use the same polarity throughout the network segment.
4
If the i-Vu® Open Router is at either end of a network segment, connect a BT485 to the i-Vu® Open Router.
5
Turn
on
the i-Vu® Open Router's power.
6
Verify communication with the network by viewing a Module Status report in the i-Vu® interface.
Summary of Contents for i-Vu CIV-OR
Page 4: ......
Page 35: ......
Page 36: ...CARRIER CORPORATION 2020 Catalog No 11 808 412 01 12 24 2020 ...
