5--3
T--311
Figure 5-6 Drivers Control Panel (Dual Systems)
5.5.2 Electrical Control Panel
The manual controls are wired to the electrical control
panel (See Figure 5-7 - Figure 5-9 - Figure 5-10) The
panel contains relays and circuit breakers used for
system control. It must be located in an area that is
protected from heat, moisture, dirt, and road hazards.
1.
2.
3.
4.
5.
6.
1..
High Speed Relay
2..
Condenser Relay
3..
Compressor Clutch Relay
4..
Circuit Breaker (HSR)
5..
Circuit Breaker (CR)
6..
Circuit Breaker (Ignition)
Figure 5-7 Electrical Control Panel (Typical)
When wiring is routed through the bus fire-wall the
cables muste be protected from the sharp edges of the
cut-out hole. Use a plastic or rubber grommet and seal
the area around the opening (See Figure 5-8).
Figure 5-8 Electrical Control Cables Thru Fire
Wall To Electrical Control Panel