T--311
2--23
Mounting Screw
Locking Tab
Locking Tab
Mounting Screw
Cut-Out Too High
Figure 2-55 In-Wall With Trimmed Cover (Front)
u
To install the metal cover to the front mounted IW-1
assembly, carefully line-up and place the two slotted
mounting tabs above the IW-1 drain pan and push down
(See Figure 2-56). The cover should slide into the drain
pan easily, with very little resistance. Making sure the
top holes are lined up properly, secure the cover with
two screws supplied with the installation kit. Tug on the
bottom of the cover to make sure it is firmly secured to
the IW-1.
NOTE
If the metal cover mounting tabs do not slide
into the drain pan easily you will have to space
out the IW-1 assembly with thin washers placed
between the bus structure rails and the IW-1
mounting plates. Do not space the IW-1 out too
far or the cover will not be snug against the front
wall.
Locking Tab
Locking Tab
Figure 2-56 In-Wall Cover - Locking Tabs