Carrier AIRSTREAM 42BHE, Installation, Start-Up And Service Instructions Manual, Page: 11 / 12

CL-1
Start-Up Checklist
The following is a checklist to be completed before start-up:
1. General visual unit and system inspection
 Yes  No
2. Check that unit is level  Yes  No
3. Record electrical supply voltage  Yes  No
4. Check all wiring for secure connections  Yes  No
5. Verify with straight edge alignment of motor and blower pulleys  Yes  No
6. Tighten all set scews  Yes  No
7. Confirm V-belt is properly tightened  Yes  No
8. Check condensate drain connection  Yes  No
9. Verify trap is deep enough  Yes  No
10. Prime the trap with water  Yes  No
11. Check supply and return water connections for leaks  Yes  No
12. Fill systems with water by opening supply ball valve and control valve  Yes  No
13. Open air vent on top of coil to vent air out of system  Yes  No
14. Open return ball valve  Yes  No
15. Engage power only long enough to verify proper blower rotation  Yes  No
16. Check all ductwork and grilles in place  Yes  No
17. Check all unit panels and filters in place  Yes  No
18. Start fans, pumps, chillers, etc.  Yes  No
19. Check for overload conditions of all units  Yes  No
20. Check all ductwork and units for air leaks  Yes  No
21. Balance water systems, as required  Yes  No
22. Balance air sytems, as required  Yes  No
23. Record all final settings for future use  Yes  No
24. Check piping and ductwork for noise or vibration  Yes  No
25 Check all dampers for proper operation  Yes  No
26. Verify proper cooling operation  Yes  No
27. Verify proper heating operation  Yes  No
28. Reinstall all covers and access panels  Yes  No
29. Verify proper condensate drainage  Yes  No