Carrier 62MB Page 78 Installation, Start-Up And Service Instructions Manual Download

Page: 78 / 82

MAINTENANCE

Routine maintenance of the energy recovery cassettes

includes periodic cleaning of the energy recovery wheel as well
as inspection of the air seals and wheel drive components as
follows:

Cleaning —

The need for periodic cleaning of the energy

recovery wheel will be a function of operating schedule, cli-
mate and contaminants in the indoor air being exhausted, and
the outdoor air being supplied to the building.

The air exchange wheel is “self-cleaning” with respect to

dry particles due to its laminar flow characteristics. Smaller
particles pass through; larger particles land on the surface and
are blown clear as the flow direction is reversed. Any material
that builds up on the face of the wheel can be removed with a
brush or vacuum. The primary need for cleaning is to remove
oil-based aerosols that have condensed on energy transfer
surfaces.

A characteristic of all dry desiccants, such films can close

off micron sized pores at the surface of the desiccant material,
reducing the efficiency by which the desiccant can adsorb and
desorb moisture and also build up so as to reduce airflow.

In a reasonably clean indoor environment such as a school

or office building, measurable reductions of airflow or loss of
sensible effectiveness may not occur for several years. Measur-
able changes in latent energy transfer can occur in shorter
periods of time in applications such as moderate occupant
smoking or cooking facilities. In applications experiencing
unusually high levels of occupant smoking or oil-based aero-
sols such as industrial applications involving the ventilation of
machine shop areas for example, annual washing of energy
transfer may be necessary to maintain latent transfer efficiency.
Proper cleaning of the energy recovery wheel will restore latent
effectiveness to near original performance.

To clean, gain access to the energy recovery wheel and

remove wheel. Brush foreign material from the face of the
wheel. Wash the wheel in a 5% solution of non-acid based coil
cleaner or alkaline detergent and warm water.

Soak in the solution until grease and tar deposits are

loosened.
NOTE: Some staining of the desiccant may remain and is not
harmful to performance.

Before removing, rapidly run finger across surface of wheel

to separate polymer strips for better cleaning action. Rinse
dirty solution from wheel and remove excess water before
reinstalling.

Air Seals —

Diameter seals are provided on each cassette

to minimize transfer of air between the counter flowing
airstreams.

To adjust diameter seals, loosen diameter seal adjusting

screws and back seals away from wheel surface (Fig. 92).
Rotate wheel clockwise until two opposing spokes are hidden
behind the bearing support beam. Using a folded piece of paper
as a feeler gage, position paper between the wheel surface and
diameter seals. Adjust seals towards wheel surface until a slight
friction on the feeler gage (paper) is detected when gage is
moved along the length of the spoke. Retighten adjusting
screws and recheck clearance with “feeler” gage.

Do not use acid based cleaners, aromatic solvents, steam or
temperatures in excess of 170 F; damage to the wheel may
result.

Bearing
Access Plate

Locking
Collar

Locking
Nut (2)

Bearing
Housing

Bearing
Support
Beam

Belt (Shown in
Place)

Wheel Rim

Wheel

Hub (2)

Taper - Lock
Hub Collar (2)

Shaft