4
PRECAUTIONS
Do not obstruct the front of the discharge
grille of both units.
This will block air flow, reduce the cooling
effect and may result in unit malfunction.
Keep heat sources away from the unit,
high temperature can cause damage.
In summer, if possible, prevent direct
sunlight from entering the room;
draw curtains or blinds.
Use the correct voltage.
Using voltage other than specified will
damage the unit.
Do not use circuit breaker as a means
of turning off the unit.
The unit must always be switched off
using remote control.
WARNING
5
Emergency Operation
BEFORE OPERATION
Ioniser(Left) light : illuminated during Ioniser activated.
Power(Right) light : illuminated during operation.
Timer(Middle) light : illuminated during timer mode.
EMER. button
When the remote control is lost, damaged or the battery is discharged, the EMER. button can be used to run the unit.
• Press the EMER. button once briefly at the off mode condition shorter than for 5 sec.
- According to the room temperature, the unit operates the Cool mode in cool only model and the Auto mode
in Heat pump model.
• If you want to stop the emergency operation, push the EMER. button again or operate the remote control.
• The setting conditions of emergency operation are as follows:
Indoor Unit Display
•
EMER. button :
Can be used when the remote
control is lost or inoperative.
EMER.
button
Test Operation
This operation is used for checking after unit installation.
• Press the EMER. button continuously during 5~10sec. And then unit will be
operated as test mode.
• Press the EMER. button once more after checking to activate the remote
control. If there is any input signal ( remote control signal or EMER. button
press ) during test operation, the TEST mode will change to the input
signal mode.
• The setting conditions of the test operation are as follows:
- Operation mode : COOL
- Fan speed : HIGH
- Timer mode : Disable
- Discharge air direction : SWING
Cooling
only
Heat
Pump
Model
Operation
Preset mode
Fan speed
Timer mode
Discharge air direction
temperature
COOL
24
°
C
AUTO
Disable
Horizontal
AUTO
25
°
C
AUTO
Disable
Preset location according
to ‘Cool’ or ‘Heat’ mode