23
INDOOR UNIT INSTALLATION
•
The piping can be connected to the four directions indicated by , , , .
When the piping is connected to the direction of , or , detach the knock-
out either at the side or at the bottom of the unit. ( Fig. 3 )
1) Installing the Wall Hang Bracket
•
Install the wall hang bracket so that it is level. Use a plumb line if necessary.
( Figure. 4 )
•
Be sure to leave the clearance spaces shown in Figure 1.
•
Before installing the wall hang bracket, remove it from the unit by pushing up
marks ( ) at the bottom of the body.
•
Fasten the wall hang bracket to the wall with 14 or more self-tapping screws
through the holes marked “ ” at the wall hang bracket.
•
Install the wall hang bracket so that there is no gap between the bracket and the wall.
•
Check that the wall hang bracket does not move to prevent noise during
operation.
Figure 3
Figure 4
NOTE
•
In case of removing the unit from the wall hang bracket after installing it
onto the wall, remove by pushing up MARKS ( ) at the bottom of
the body.
10cm
or more
45cm
or more
PLUMB
REMOVE SCREW
30cm
or more