Carrier 42TVGS010-703, Owner'S Manual

Page: 12 / 16

The unit does not operate. Cooling is abnormally low.
● The power main switch is
turned off.
● The circuit breaker is
activated to cut off the power
supply.
● Stoppage of electric current.
● ON timer is set.
● The fi lters are blocked with dust.
● T h e t e m p e r a t u r e h a s b e e n s e t
improperly.
● The windows or doors are opened.
● The air inlet or outlet of the outdoor unit
is blocked.
● The fan speed is too low.
● The operation mode is FAN or DRY.
TROUBLESHOOTING (CHECK POINT)
REMOTE CONTROL A-B SELECTION
To separate using of remote control for each indoor unit in case of 2 air
conditioners are installed nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn the air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold
button on the Remote Control by the tip of the
pencil. “00” will be shown on the display . ( Picture )
4. Press
MODE
during pushing . “B” will show on the display and
“00” will disappear and the air conditioner will turn OFF. The Remote
Control B is memorized. ( Picture )
Note: 1. Repeat above step to reset Remote Control to be A.
2. Remote Control A has not “A” display.
3. Default setting of Remote Control from factory is A.
1 2
AUTO RESTART OPERATION 14
To automatically restart the air conditioner after the power failure (Power of
the unit must be on.)
Setting
1. Press and hold the RESET button on the indoor unit for 3 seconds to set
the operation. (Pi Pi Pi sound and OPERATION lamp blink 5 time/sec for
5 seconds)
2. Press and hold the RESET button on the indoor unit for 3 seconds to
cancel the operation. (Pi Pi Pi sound but OPERATION lamp does not
blink)
● In case of ON timer or OFF timer are set, AUTO RESTART OPERATION
does not activate.
19
20
For ECO sleep automatically control air fl ow and automatically turn OFF.
Press : Select 1, 3, 5 or 9 hrs for OFF timer operation.
Note: The cooling operation, the set temperature will increase automatically
1 degree/hour for 2 hours (maximum 2 degrees increase).
ECO SLEEP OPERATION
Firstly, turn off the circuit breaker.
Indoor Unit and Remote Control
● Clean the indoor unit and the remote control with a wet cloth when needed.
● No benzine, thinner, polishing powder or chemically-treated duster.
Air fi lters
Clean every 2 weeks.
1. Open the air inlet grille.
2. Remove the air
fi lter.
3. Vacuum or wash and then dry them.
4. Reinstall the air
fi lters and close the air inlet grille.
MAINTENANCE
OPERATION AND PERFORMANCE
1. Three-minute protection feature: To prevent the unit from being activated
for 3 minutes when suddenly restarted or switched to ON.
2. Some minor cracking sound may occur when unit operating. This is
normal because the cracking sound may be caused by expansion/
contraction of plastic.
Air conditioner operating conditions
Temp.
Operation
Outdoor Temperature Room Temperature
Cooling -10°C ~ 46°C 21°C ~ 32°C
Dry -10°C ~ 46°C 17°C ~ 32°C
SELF CLEANING OPERATION
(COOL AND DRY OPERATION ONLY)
To protect bad smell caused by the humidity in the indoor unit.
1. If the button is pressed once during “Cool” or “Dry” mode,
the fan will continue to run for other 30 minutes, then it will turn off
automatically. This will reduce the moisture in the indoor unit.
2. To stop the unit immediately, press the more 2 times within
30 seconds.
15
16
17
18
1
2
@TeddyAir 095-323-9555
www.TeddyAirCond.com