background image

1

installation manual

Be sure to be in conformity with the local, national and 
international laws and regulations.

Read "PRECAUTIONS" carefully before installation.

The following precautions include important safty items. 
Observe them and never forget.

Keep this manual with the owner's manual in a handy place 
for future reference.

1.    PRECAUTIONS

The safty precautions listed here are divided into two categories.

After completing the installation, make sure that the unit operates 
properly during the start-up operation. Please instruct the customer 
on how to operate the unit and keep it maintained.Also, inform 
customers that they should store this installation manual along with 
the owner's manual for future reference.  

Be sure only trained and qualified service personnel to 
install, repair or service the equipment.

Improper installation, repair, and maintenance may result in 
electric shocks, short-circuit, leaks, fire or other damage to 
the equipment.

Failure to observe a warning may result in death.

Failure to observe a caution may result in injury or 
damage to the equipment.

CONTENTS

PAGE

1. PRECAUTIONS...................................................................... 

2.  INSTALLATION INFORMATION

3. ATTACHED FITTINGS
4. INSPECTING AND HANDLING THE UNIT........................ 
5. INDOOR UNIT INSTALLATION
6. OUTDOOR UNIT INSTALLATION....................................

8. INSTALL THE CONNECTING PIPE

7. REFRIGERANT PIPE

9. CONNECT THE DRAIN PIPE...........................................
10. WIRING
11. TEST OPERATION.........................................................

Install according to this installation instructions strictly. 

If installation is defective, it will cause water leakage, 
electrical shock and fire.

When installing the unit in a small room, take measures 
against to keep refrigerant concentration from exceeding 
allowable safety limits in the event of refrigerant leakage.

 

Contact the place of purchase for more information. 
Excessive refrigerant in a closed ambient can lead to oxygen 
deficiency.

Use the attached accessories parts and specified parts 
for installation. 

otherwise, it will cause the set to fall, water  leakage, 
electrical shock and fire.

Install at a strong and firm location which is able to 
withstand the set' s weight. 

If the strength is not enough or installation is not properly 
done, the set will drop to cause injury.

The appliance must be installed 2.5m above floor.

The appliance shall not be installed in the laundry.

Before obtaining access to terminals, all supply circuits 
must be disconnected.

The appliance must be positioned so that the plug is 
accessible.

The enclosure of the appliance shall be marked by word, 
or by symbols, with the direction of the fluid flow.

For electrical work, follow the local national wiring 
standard, regulation and this installation instructions. An 
independent circuit and single outlet must be used. 

If electrical circuit capacity is not enough or defect in 
electrical work, it will cause electrical shock or fire.

Use the specified cable and connect tightly and clamp 
the cable so that no external force will be acted on the 
terminal.

 

If connection or fixing is not perfect, it will cause heat-up or 
fire at the connection.

Wiring routing must be properly arranged so that control 
board cover is fixed properly. 

If control board cover is not fixed perfectly, it will cause 
heat-up at connection point of terminal, fire or electrical 
shock.

If the supply cord is damaged, it must be replaced by the 
manufacture or its service agent or a similarly qualified 
person in order to avoid a hazard.

An all-pole disconnection switch having a contact 
separation of at least 3mm in all poles should be 
connected in fixed wiring.

When carrying out piping connection, take care not to let 
air substances go into refrigeration cycle. 

Otherwise, it will cause lower capacity, abnormal high 
pressure in the refrigeration cycle, explosion and injury.

Do not modify the length of the power supply cord or use 
of extension cord, and do not share the single outlet with 
other electrical appliances. 

Otherwise, it will cause fire or electrical shock.

Carry out the specified installation work after taking into 
account strong winds, typhoons or earthquakes.

Improper installation work may result in the equipment falling 
and causing accidents.

CAUTION

WARNING

WARNING

......................................... 

...................................................... 

................................................ 

..........................................................................

.................................

.......................................................

1
2
3
4
4
9

10
11
13
14
15

12. DR CONTROL BOX INSTRUCTIONS.............................

17

Summary of Contents for 42TSV052P1






















Reviews: