Restrictions to connection may be imposed by the supply authority on the use of
equipment if the actual system impedance at the interface point on the user s premises
exceeds 0.12ohm
.
The unit complies with low-voltage (EEC/73/23) and electromagnetic compatibility
(EEC/89/336) directives.
Carefully recover refrigerant within this unit before final disposal or when servicing.
Never vent refrigerant to atmosphere.
ALL of the manufacturing and packageing material used for your new appliance are
compatible with the environment and can be recycled.
Disconnect the mains power supply switch and wait over 2 minutes without toughing
any internal parts of the unit before servicing the system or handing any internal parts
of the unit.
All field electrical connections are the responsibility of the installer
.
If not using plug, ensure that mains supply connection is made through a switch that
disconnects
all poles, with contact gap of a least 3mm
.
There are some kinds of cord clamp in the accessory parts If cord clamp is not used as
specified , the power cable and interconnection wire will be damaged.
The equipment contains R-407C refrigerant, a substance that is not depleting the ozone
layer but
must be disposed of in a proper manner. When disposing of the unit after its
operational life,remove it carefully.
Check that the impedance of the mains power supply is in conformance with the unit
power
input indicated in the electric (EN 61000-3-11)
.
Control batteries contain polluting elements.When exhausted they must be disposed
of according to local requirements.
After the installation thoroughly test system operation and explain all system
functions to the owner.
Leave this manual with the owner for consultation during future periodic maintenance.
Use this unit only for factory approved applications:the unit cannot be used in laundry
or steam pressing premises.
Follow all current national safety code requirements. In particular ensure that a property
sized and connected ground wire is in place.
Check that voltage and frequency of the mains power supply are those required for the
unit to be installed;the available power must be adequate to operate any other possible
appliances connected to the same line.
The manufacturer declines any liability for damage resulting from modifications or
errors in the electrical or refrigerant connections.
Failure to observe the installation instructions or use of the unit under conditions other
than those indicated in operating limits , will immediately void the unit warranty.
Failure to observe electric safety codes may cause a fire hazard in case of short circuits.
Inspect equipment for damage due to improper transportation or handing :file an
immediate claim with the shipping company.Do not install or use damaged units.
42HQE009(012)/38YE009(012)
GB-2
