![background image](http://html1.mh-extra.com/html/carrier/38nyv050m-series/38nyv050m-series_service-manual_2560737089.webp)
–
88
–
Inverter cover
P. C. board
(Soldered surface)
Discharging position
(Discharging period
10 seconds or more)
Plug of
soldering
iron
No.
Part name
Inverter
assembly
Procedure
1) Perform work of item 1 in
.
2) Remove screw (ST1TØ4 × 8L 2 pcs.) of the
upper part of the front cabinet.
• If removing the inverter cover in this
condition, P.C. board can be checked.
• If there is no space above the unit, perform
work of 1 in
.
Be careful to check the inverter because
high-voltage circuit is incorporated in it.
Be careful to discharge the capacitor
because the electrolytic capacitor
cannot naturally discharge and voltage
remains according to trouble type in
some cases.
NOTE
This capacitor is one with mass capacity.
Therefore, it is dangerous that a large
spark generates if short-circuiting
between
,
polarity with screwdriver,
etc. for discharging.
4) Remove screw (ST1TØ4 × 8L 2 pcs.) fixing
the main body and the inverter box.
5) Remove the front cabinet by performing step
1 in
, and remove the fixing screws
(ST1TØ4 × 8L) for securing the main body
and inverter box.
6) Remove various lead wires from the holder
at upper part of the inverter box.
7) Pull the inverter box upward.
8) Disconnect connectors of various lead wires.
Requirement
As each connector has a lock mecha-
nism, avoid to remove the connector by
holding the lead wire, but by holding the
connector.
Remarks
The connector is one
with lock, so remove
it while pushing the
part indicated by
an arrow.
Be sure to remove the connector by
holding the connector, not by
pulling the lead wire.
3) Perform discharging by connecting
38NYV060M=760
µ
F) on P.C. board.
,
polarity by discharging resistance (approx.
100
Ω
40W) or plug of soldering iron to
,
terminals a of the C14 (printed “CAUTION
HIGH VOLTAGE” is attached.) electrolytic
capacitor (38NYV050M= 500µF,
A screw
(STIT-4X8MSZN) Terminal block
Put the compressor
leads through
the hole
Put each leads
through the hole