Item
Operation flow and applicable data, etc.
Description
−
36
−
12. Remote-A or B
selection
1. Purpose
This operation is to operate only one
indoor unit using one remote controller.
2. Description
When operating one indoor unit in a
situation where two indoor units have
been installed in the same room or
nearby rooms, this operation prevents the
remote controller signal from being
received simultaneously by both units,
thus preventing both units from operating.
3. Operation
The indoor unit on which the remote
controller selection has been set to B
receives the signal of the remote control-
ler also set to B.
(At the factory the remote controller
selection is set to A on all the indoor
units. There is no A setting display.)
Setting the remote controller
To separate using of remote control for each indoor
unit in case of 2 air conditioner are installed nearly.
Remote Control B Setup.
1) Press RESET button on the indoor unit to turn
2) Point the remote control at the indoor unit.
3) Push and hold
button on the Remote Control
by the tip of the pencil. "00" will be shown
on the
the air conditioner ON.
display.
4) Press
during pushing CHK
•
. "B" will
show on the display and "00" will disappear and
the air conditioner will turn OFF. The Remote
Control B is memorized.
Note : 1. Repeat above step to reset Remote Control
to be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from
factory is A.
"B" Display
"00" Display
13. Short Timer
In the normal condition, after switching one circuit
breaker, 3-minute delay time for compressor
is
set for the
maintenance of the unit.
Purpose
To start the unit immediately for the purpose of
testing, trial...etc, short timer can be used.
maintenance of the unit.
Short Timer Setting
control without
sending the signal to
[CHK] button and hold, "00" will show
to make "00" disappear.
setting on the remote operates
front panel turns ON continuously for
j
Press [ ] button to turn the unit OFF.
k
Set the operation mode
on the remote
the unit.
l
Use the tip of the pencil to push the
on display, them press [
] button
m
Press [ ] button to turn the unit ON.
n
When short timer is activated, all
immediately, besides, all indicatiors on
3
seconds.
ON
OFF
•
„
ƒ