4
How to install the air inlet grille on the
indoor unit
• When attaching the air inlet grille, the contrary of the
removed operation is performed.
Piping and Drain Hose Installation
* Since dewing results in a machine trouble, make sure to
insulate both connecting pipes. (Use polyethylene foam as
insulating material.)
Piping and drain hose forming
1. Die-cutting front panel slit
Cut out the slit on the leftward or right side of the front panel
for the left or right connection and the slit on the bottom left
or right side of the front panel for the bottom left or right con-
nection with a pair of nippers.
2. Changing drain hose
For leftward connection, bottom-leftward connection and
rearleftward connection’s piping, it is necessary to change
the drain hose and drain cap.
• This appliance can be connected to the mains in either of
the following two ways.
(1)
Connection
to
fi xed wiring:
A switch or circuit breaker which disconnects all poles
and has a contact separation of at least 3 mm must be
incorporated in the fi xed wiring. An approved circuit
breaker or switches must be used.
(2) Connection with power supply plug:
Attach power supply plug with power cord and plug it
into wall outlet. An approved power supply cord and
plug must be used.
NOTE
• Ensure all wiring is used within its electrical rating.
Wiring Connection
Wiring of the connecting cable can be carried out without
removing the front panel.
1. Remove the air inlet grille.
Open the air inlet grille upward and pull it toward you.
2. Remove the terminal cover and cord clamp.
3. Insert the connecting cable (according to the local cords) into
the pipe hole on the wall.
4. Take out the connecting cable through the cable slot on the
rear panel so that it protrudes about 15 cm from the front.
5. Insert the connecting cable fully into the terminal block and
secure it tightly with screws.
6. Tightening torque : 1.2 N·m (0.12 kgf·m)
7. Secure the connecting cable with the cord clamp.
8. Fix the terminal cover, rear plate bushing and air inlet grille
on the indoor unit.
How to connect the connecting cable
• Be sure to refer to the wiring system diagram labeled
inside the front panel.
• Check local electrical cords and also any specifi c wiring
instructions or limitations.
NOTE
• Use stranded wire only.
• Wire type : H07RN-F or more
How to remove the drain hose
• The drain hose can be removed by
take off screw, after that twisting and
pulling.
• When removing the drain hose, be
careful of any sharp edges of steel
plate. The edges can cause injuries.
CAUTION
CAUTION
Model
42CSR010
42CSR013
Power source
50Hz, 220-240 V Single phase
Maximum running current
7.5A
12A
Plug socket & fuse rating
16A
Power cord
1 mm
2
or more
1.5 mm
2
or more
Terminal cover
Cord clamp
Terminal block
Earth line
Connecting cable
Screw
Screw
Screw
60 mm
10 mm
10 mm
50 mm
Connecting cable
Earth line
about 150 mm
Stripping length of the connecting cable
Rear right
Rear left
Bottom left
Left
Bottom right
Right
Die-cutting
front panel slit
Changing
drain hose
Piping preparation
Heat insulator
Drain hose
1110251169-EN.indd 4
1110251169-EN.indd 4
3/21/08 4:30:05 PM
3/21/08 4:30:05 PM
Downloaded from AC-Manual.com Manuals