8
OTHERS
OTHERS
Gas Leak Test
Setting of Remote Control
Selector Switch
Test Operation
To switch the TEST RUN (COOL) mode, press RESET button
for 10 seconds. (The beeper will make a short beep.)
Auto Restart Setting
The product was shipped with Auto Restart function in the
off position. Turn it on as required.
How to set the Auto Restart
RESET
Remote Control A-B Selection
Note : 1. Repeat above step to reset Remote Control to be
A.
2. Remote Control A has not “A” display.
3. Default setting of Remote Control from factory is A.
To separate using of remote control for each indoor unit in case
of 2 air conditioners are installed nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn the air
conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold button on the Remote Control by the tip of
the pencil. “00” will be shown on the display.
4. Press
during pushing . “B” will show on the display
and “00” will disappear and the air conditioner will turn OFF.
The Remote Control B is memorized.
Remote control selector switch
• When two indoor units are installed in the same room or
adjacent two rooms, if operating a unit, two units may
receive the remote control signal simultaneously and
operate. In this case, the operation can be preserved
by setting either one indoor unit or remote control to B
setting. (Both are set to A setting in factory shipment.)
• The remote control signal is not received when the
settings of indoor unit and remote control are different.
• There is no relation between A setting/B setting and A
room/B room when connecting the piping and cables.
When two indoor units are installed in the separated
rooms, it is not necessary to change the selector
switches.
• Check the fl are nut connections for the gas leak with a gas
leak detector or soap water.
This product is designed so that, after a power failure, it can
restart automatically in the same operating mode as before the
power failure.
• Press and hold the RESET button for about 3 seconds. After
3 seconds, the electronic beeper makes three short beeps to
tell you the Auto Restart has been selected.
• To cancel the Auto Restart, follow the steps described in the
section Auto Restart Function of the owner’s manual.
Information
“B” Display
“00” Display
Check places for
the indoor unit.
Valve cover
Electric parts cover
Check places for
the outdoor unit.
RESET button
1110251169-EN.indd 8
1110251169-EN.indd 8
3/21/08 4:30:12 PM
3/21/08 4:30:12 PM
Downloaded from AC-Manual.com Manuals
