CARRE PENTASEM Series, Assembly & Use Instructions, Page: 17 / 44

16
During the fixed station flow inspection, proceed as follows:
1- Do you want to perform a flow control for common seed or with fine seed?
2- Types of seed
a-
For common seed, place the inverter C on the dispenser and the spring clamp of the
blower adjustment flap to open position [ 1 ] (in the axis of the pipe) and place
sprocket A in sprocket B.
b- Adjust smaller doses only if the dispenser is running or if the hopper is empty.
Otherwise, you run the risk of deteriorating the dispenser by pressing on the seed.
For fine seed, turn the threaded rod until the value 0 is shown in the graduated
sector. Then turn the inverter C to the right, until it snaps into the groove of the hex
shaft.
Also position the spring clamp of the blower air adjustment flap to position [ 2 ] and
take out sprocket A so that it drives sprocket C.
3- Use the settings table to locate the value that corresponds to the quantity to sow.
4- The graduated sector indicates values from 0 to 110 (only up to 25 for small seeds).
Turn the threaded rod until the value of the setting appears against the notch of the
case.
A
B
A
C
B
1
2
C
2