background image

3108/3112/3113/3120/3121 — OPERATING MANUAL AND PARTS LIST

3

rev. 08/07/03

TROUBLESHOOTING

SYMPTOM

POSSIBLE CAUSE

CORRECTIVE ACTION

Will not lift to full height

Reservoir could be overfilled

With jack upright, remove filler screw or filler plug, 

Will not lower completely

open release and SLOWLY push jack ram into 
lowered position. Any excess oil will run out fill 
hole. Replace filler screw or filler plug when oil has 
stopped flowing.

Will not lift load

The jack could be low on oil

With jack in upright position and ram fully lowered, 

Will not lift full height

remove filler screw or filler plug and fill reservoir 

Pump feels “spongy” under load

with clean hydraulic fluid. Correct oil level is 
reached when oil level is at bottom edge of fill hole.

Will not lift load

Valve may not be closing

Make certain release valve is closed. Starting with 

Handle raises under load

ram in fully lowered position, SLOWLY raise ram 

Handle lowers under load

out to full height. Open release valve and push ram 
down into lowered position. Jack should now 
operate properly.

Will not lift load

Overload condition

Remedy overload condition.

Will not work in horizontal position.

The jack could be low on oil

With jack in upright position and ram fully lowered, 
remove filler screw or filler plug and fill reservoir 
with clean hydraulic fluid. Correct oil level is 
reached when oil level is at bottom edge of fill hole.

3120 Only
Will not pump up to full extension

Vent screw tight

Loosen vent screw

SPECIFICATIONS

Model No.

3108

3112

3113

3120

3121

Capacity

8  ton

12 Ton

12 Ton

20 Ton

20 Ton

Closed Height

9"

9"

6-3/4"

11"

7"

Extension Screw

4-1/4"

3-3/8"

n/a

n/a

n/a

Maximum Height

19-3/4"

18-1/2"

9-7/8"

19"

11"

Power Lift

6-1/2"

6-1/8"

3-1/8"

8"

4"

CARQUEST PROFESSIONAL LIFTING EQUIPMENT WARRANTY STATEMENT

CARQUEST warrants that all jacks and service related equipment
will be free from defects in material and workmanship for a 
period of 1 year following the original date of purchase. This 
warranty is extended to the original retail purchaser only. If 
any CARQUEST Professional Lifting item proves to be defective
during this period, it will be replaced or repaired, at our option,
without charge. This warranty does not apply to damage from
accident, overload, misuse or abuse, nor does it apply to any
equipment which has been altered or used with special 
attachments other than those recommended. This warranty does
not cover repairs made by anyone who is not a CARQUEST
Professional Lifting Equipment Authorized Repair Center.

The following items possess an over-the-counter exchange 
warranty for 1 year. This allegedly defective product must be
returned, accompanied by a receipt showing proof-of-purchase
to a CARQUEST Auto Parts store.

• Bottle Jacks: 3108, 3112, 3113, 3120, 3121

• Floor Jacks: 3202, 3235

• Stands:

3203, 3206, 3210, 3211, 3207

All other jacks or service-related equipment will be replaced or
repaired at CARQUEST’s option during the 1 year warranty period.

During the 1 year warranty period, all alleged defective product
and/or part must be shipped, freight prepaid, along with proof
of date-of-purchase, to your nearest CARQUEST Professional

Lifting Equipment Authorized Warranty Center. Be certain to
include your name, address and phone number along with
proof-of-purchase information, and a brief description of the
alleged defect. The product will be returned to the customer,
freight prepaid.

Many alleged defectives may simply be handled by calling your
nearest Service Center for parts. See next page for a listing of
authorized warranty service centers.

In no event shall CARQUEST be liable for incidental or 
consequential damages. The liability on any claim for loss or
damage arising out of the sale, resale or use of a jack or related
service equipment, shall in no event exceed the purchase price.
SOME STATES DO NOT ALLOWTHE EXCLUSION OR LIMITATION
OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE
ABOVE LIMITATION MAY NOT APPLY TO YOU.

THIS WARRANTY IS THE SOLE AND EXCLUSIVE WARRANTY
PROVIDED IN CONNECTION WITH THE SALE OF CARQUEST 
PROFESSIONAL LIFTING EQUIPMENT. ALL OTHER WARRANTIES,
INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, ARE EXCLUDED.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND 
YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE
TO STATE.

3108to3121man080703  8/7/03  9:23 AM  Page 3

Summary of Contents for PROFESSIONAL LIFTING 3108










Reviews: