P a g e |
35
In the
Internet Protocol Version 4 (TCP/IPv4) Properties
window, select
Obtain an IP address
automatically
and
Obtain DNS server address automatically
.
Ensure the PC’s Wi-Fi adaptor is physically switched on, if required, and that it is not disabled in the
Change
adaptor settings
window.
7.4 Connection with PC
Switch on the VS+ so that Internal Power Source button is illuminated.
On the PC, in the task bar, click on the Wi-Fi icon to see the available Wi-Fi networks. The VS+ is identified by its
serial number. In the case below, the VS+ Wi-Fi network is named
VS+_190551
.
Click on the appropriate network and allow the PC to connect with the VS+.
You are now ready to run
Carlson Scan
.
7.5 Carlson Scan
A full description of
Carlson Scan
software is included in the
Carlson Scan
manual which accompanies the VS+
system. This section is concerned only with connecting
Carlson Scan
to the VS+.
Once the VS+ is connected to the PC (see section 7.4), start
Carlson Scan
software as normal.
Carlson Scan
has an autodetect routine to establish if there are any scanners connected to the PC. Once the
routine is initiated, any scanner which is powered on and correctly interfaced with the PC is detected.
Carlson Scan
first identifies that a VS+ is connected and then establishes the serial number, firmware and internal sensors within
the instrument.
The autodetect routine can be started automatically by tapping the
Quickstart
option from the
Touch
mode
Home
screen. This is the quickest way to get started with scanner operations.
On detection of a VS+,
Carlson Scan
runs through checks to establish that comms with the scanner are sound and
to read information from the VS+.
Figure 37 Wi-Fi network connections
