Car Park 3 – General installation
16
3.5 Mounting the sensor to the base
Note: the procedure below is the same for mounting the sensor on the SBPBASEA or SBPBASEB
bases. The base must be installed on the ceiling (according to the method shown above) and wired
(see the
Electrical installation
chapter).
1) Connect the sensor to the base with RJ12
connector
2) Place the sensor mark vertically so that it
points towards the base of the triangle (see
the picture)
3) Twist the sensor clockwise until the vertical
mark is positioned at the end of the triangle. The
sensor is now fixed to the base.
4) Turn the screwdriver anti-clockwise for
sealing the sensor to the base (see the
picture)
