OPERATION
EN
SI-21-06-R1 (11/2021)
25 / 32
www.carlisleft.com
Step 26
Step 25
Locate Spacer and Shaft
Important Assembly Note:
Inspect spacer and shaft to make sure, that
they have corresponding serial numbers.
They are a matched set. If numbers do not
match locate ones that do match. Failure to
do so will result in turbine motor failure.
Step 27
Assemble Spacer Ring onto Bearing
Housing
Assemble Spacer & Second O-Ring:
Align pin on body with hole near bearing air.
Align spacer before installing shaft.
Assemble Shaft into Bearing Housing
Assemble Shaft:
Assemble shaft into bearing housing as shown
in Figure 1-27. Use care during installation.
Align Pin
Bearing
Air Hole
Figure 1-25
Figure 1-26
Figure 1-27