OPERATION
EN
SI-21-06-R1 (11/2021)
22 / 32
www.carlisleft.com
Step 20
Step 19
Lay out bearings for installation
Position Assembled Bearings:
Lay out bearings for install as shown. Note the
“taper end” goes inward towards the housing.
Remember the set screw holes must align with
bearing housing.
NOTE
Prior to assembly, go back through and make
sure that all component parts are clean. If not,
wash them with 99% pure Isopropyl Alcohol and
wipe with a lint free cloth. All parts must be very
clean. Use safety glasses and latex gloves during
cleaning operation. Do not apply solvents to
O-Rings, swelling will occur, replace as needed
with new kit.
Install O-Rings:
Locate O-rings from replacement kit and install onto bearing
as shown in Figure 1-19. Please note new bearings may
need to be installed if required. New bearings are included
with the rebuild kits. (A12951-01)
Figure 1-19
Assemble Bearings back into
Bearing Housing
Install new O-rings onto Bearings
(Note: Radial Bearings are the Same
Size and can be interchanged)
Figure 1-20
Tapered end
in first