Carl Valentin FLEXICODE 53, Operating Manual, Page: 76 / 120

Function Menu Flexicode
76 Operating Manual 11.19
7.18 Main Menu
Switch on the control unit and the display shows the main menu. The
main menu shows information such as device type, current date and
time, version number of firmware and the used FPGA.
The selected display is shown for a short time, then the indication
returns to the first information.
Press the key to move to the next information display.
7.19 Display During Printing
The direct print module is in 'waiting' mode, i.e. ready to receive data.
Press the key to interrupt an active print order.
The display shows the following:
Press the key key to continue the interrupted print order.
In case an active print order was interrupted by means of key
and afterwards the key pressed, then the print order was
cancelled and the direct print module changes to the main menu.
During the print order the number of layouts which already printed is
indicated. Press the key to move to the menu item Material speed .
Press the key to move to the menu item Print offset . The print
offset can be changed during the running print order.
Press the key and the direct print module changes again to the
initial position, i.e. to the 'waiting' mode.
TESTETI: wait
printed: 00000
TESTETI: ST 0
printed: I00000
Material speed
300 mm/s
Print offset
(mm) 10.0