Flexicode
Function Menu
11.19
Operating Manual
67
7.11 I/O Parameters
Switch on the control unit and the display shows the main menu.
Press the key
to access the function menu.
Press the key
until the menu
IO parameters
is displayed.
Press the key
to select the menu.
Definition of port functions:
2 sign show the current setting for each port.
The first sign specifies the following:
I
= Port operates as Input
O
= Port operates as Output
N
= Port has no function (not defined)
These settings cannot be modified.
The second sign specifies the following:
+
= Active signal level is 'high' (1)
−
= Active signal level is 'low' (0)
x
= Port is deactivated
&
= Function is executed at each change of the signal level
s
= Status can be enquired/influenced
=
(in connection with Netstar PLUS) by interface
=
The printer-internal function is deactivated.
Press the key
to move to the next menu item.
Indication of debounce time of the dispenser input. The setting range
of the debounce time is between 0 and 100 ms.
In case the start signal is not clear then you can debounce the input
by means of this menu item.
Press the key
to move to the next menu item.
Indication in time per second of the delay for the start signal.
Value range: 0.00
… 9.99.
Press the key
to move to the next menu item.
On:
If a print order is active but the direct print module is not ready to
process the order (e.g. if it is already in 'printing' mode), then an error
message appears.
Off:
No error message appears.
Press the key
to move to the next menu item.
On:
The start signal for the next label can already be released during
printing the current label. The signal is registered from the printing
system. The printing system starts printing the next label immediately
after finishing the current one. Therefore time can be saved and
performance be increased.
Off:
The start signal for the next label can only be released if the
current label is printed to the end and the printing system is again in
'waiting' state (output 'ready' set). If the start signal was released
already before, so this is ignored.
I/O Port 1-8 and
I/O Port 9-16
Debounce
Start signal delay
(intermittent mode)
Not ready: Error
Save signal
(intermittent mode)
Summary of Contents for FLEXICODE 53
