6
1. While the epoxy dries on the stab, mount the
control horns on the elevators. Align on the
inside edge of elevator on the bottom side, with
the holes on the horn aligned over the hinge line.
Use a square to check alignment of holes over
hinge line, this is important to maintain even
throw on both elevators. Use a long drill, piece of
wire, or pencil to mark the holes through the con-
trol horn. Remove the horn and drill the holes
using a 5/64” drill.
Mount the horns to the elevators using the 2-56
x3/4” bolts and the nylon plates on top of the
elevator.
2. Install the e-z hinges in the stab using a pin
in the center of each to make sure they stay
aligned.
3.Install the elevators on the hinges and with the
elevators pushed tightly against the stab,
remove the pins. Using thin CA, glue each hinge
in place by applying two to three drops on each
hinge. Have the elevators deflected to full up
when gluing the bottom side of the hinges and
deflected to full down when gluing the top side
of the hinges. This will insure that you can get
full throw later.
PLACE CONTROL HORN
AT HINGE LINE
2-56 x 3/4” SCREWS
SNAP LINK
CONTROL
HORN
1. Locate the tail wheel bracket, mounting screws,
wheel and wheel collar.
T
T
AIL
AIL
WHEEL
WHEEL
BRACKET
BRACKET
Control Horns
