11
Ailerons
1. Hinge the ailerons on to the wing using pins
and Thin CA just like the elevators and rudder.
2. Locate the servo hole in the wing and remove
the covering with a #11 blade.
8-1/4”
4”
3. Install the servo using the hardware supplied
with the radio. Inside the cutout you will find a
piece of nylon fishing line to pull the aileron
lead to the center of the wing. Tape your servo
lead to the fish line and pull it out the hole in
the center of the wing.
Bottom side of wing
4. Install a control horn on the servo and center
the servo with the arm paralle to the hinge line.
Locate the position for the control horn by laying
a 90 degree triangle down. Keeping the bottom
of the triangle parallel to the hinge line and the
top even with the outer servo arm hole.
Aileron
5. Mark the location and drill two 5/64” holes.
Mount the horns using the 2-56 x 3/4” screws
6. Screw a 4-40 nut and metal clevis on each
end of the 4-40 pushrod. Adjust the length of the
pushrod till the aileron is level.
Tighten the nuts against each clevis.
Place the clevis clip onto each of the 4-40 clevis-
es.
